To use switch scanning on I-110 and Indi, it must first be setup in Snap+ Core First.

  1. Open Snap and set the access method to Scanning
  2. Close Snap and load ‘Windows Setting Utility’
  3. Check Switch 1 Input is ‘Left Arrow’, and Switch 2 Input is ‘Right Arrow’
  4. If boxes are blank, reboot the device
  5. Load ‘Windows Setting Utility’ and check the boxes are now filled in
  6. If boxes are still blank, run ‘Configuration Manager’

For further support contact Link Assistive support@linkassistive.com